Fitting roof ventilation tilesand or ventilated soffits under the roof and guttering to allow air through the loft adding window ventsto the tops of window frames.
Roof to be properly ventilation to avoid condensation.
The physics of condensation the air around us contains water in its gas phase water vapor.
But with proper design and maintenance principles you don t have to sweat roof condensation issues although moisture problems in the roof assembly can be due to waterproofing deficiencies don t neglect the effect of condensation.
Roof tile ventilation advice.
The real key to avoiding moisture and condensation problems in low slope and flat roofs though is to keep moisture out of the ceiling in the first place.
If your roof deck or insulation is developing water droplets chances are your forehead is too.
Bear in mind that these measures may mean that some heat is lost from your house so balance that against your damp issue.
This includes defects in the roof membrane leaks at penetrations at parapet walls and at any other flashings on flat and low slope roofs.
But in low slope roofs with no attic space ventilation is typically inadequate.
Bs 5250 offers minimum requirements for roof ventilation.
Fix the roof leaks.
As such roofs will always require some form of supplementary low and high level ventilation in accordance with bs 5250.
Fighting condensation factor 3 cheating the system.
Depending on a building s use and location some scenarios can.
All cold roofs should have some form of roof ventilation in place to prevent warm air condensing in the loft.
Prevent moist air from entering the roof space and ensure there is adequate ventilation and air flow in the roof space to carry any moisture laden air to outside the roof space.
Preventing warm moist air from entering the roof space.
How can roof ventilation fight condensation in the loft.
In steep slope roofs with attic space ventilation is a reasonable tool to counter the risk of condensation.
Because a ventilation system is only as good as its weakest point as chris says the wet air is not moved effectively.
It recommends that with cold roof constructions uninhabited unheated loft spaces where the insulation is laid over a horizontal ceiling there should be at least a 7mm continuous ventilation gap at the eaves when using a vapour permeable underlay with a normal unsealed ceiling.
Even a properly ventilated building can find itself in a situation where sources of moisture and weather conditions overwhelm the system.
The solution to condensation in roofs is straightforward.
However the british standard bs 5250 code of practice for the control of condensation in buildings does not include the option of no ventilation to the roof void.
The ventilation holes must all be free from any.