Roof Tile Installation Instructions

Look at the advanced weather forecast before you begin and choose a few weeks with as many dry days as possible.

Roof tile installation instructions.

If the plumbing vent is close to the peak of the roof lap the shingles over the peak of the roof. Florida high wind concrete and clay tile installation manual 6th edition revised. 7685988 vat no. Corrosion resistant roof nails or fasteners of compatible metals.

The first raw of fixings at eave is located at 2 5 cm. Attach he ridge cap shingles with two nails each. When installing ensure that drip edge is straight and square to the roof plane and does not follow any wave in the fascia. Position the ridge cap shingles over the ridge vent.

Install the underlayment for the new roof tile next working with 10 foot sections at a time. Rake seal flyer and installation instructions. The metal and underlayment shall be joined with a bed of flashing cement and a 4 strip of asphalt saturated cotton or fiberglass fabric. Concrete and clay roof tile installation manual july 2015.

Secure the underlayment with nails that are at least 2 inches from the edge of the roof. Find the resources you. Installation could be realized either on full deck like on osb panels recommended or on discontinuous support with purlins every 36 6 cm center to center. Frsa have been working together for over two decades on the development of installation manuals that represent proper installation practices industry standards and the latest code requirements of roof tiles for the florida market.

Trim the shingles away from the ridge vent hole. Fasten drip edge to the roof deck every 12 with panhead screws. To begin remove the old roof tile. Construction usually takes around 1 2 days to get a concrete or terracotta tile roof installed and 1 day for a composite tile roof.

The metal shall be fastened 6 on center with 12 ga. For specialist services please view the find a roofing specialist. Tri snow cold installation guide. 15 start laying sheets over the gutter with 6 cm overhang maximum.

Minimum pitch required. Attach the plastic ridge vent with 3 roofing nails. December 31 2020 the tile roofing industry alliance tri in partnership with the florida roofing and sheet metal contractors association inc. This may require a chalk line.