Roof Tile Batten Centres

Rafter centres to 600mm metal top span t s 40.

Roof tile batten centres.

For rafter centres up to 450mm centres all tile roof coverings and fc slate should use 38mm x 25mm battens while natural slates should use 50mm x 25mm. In a new build situation saw the tiling. 3 3 bellcast battens tilting batten 3 4 recommended batten sizes and types 3 5 batten sizes and rafter spacings mm. This is important because the correct gauge and head lap has a direct influence on a tile s ability to withstand the ingress of rainwater through capillary ensuring that the roof remains watertight.

Colour range black anthracite brown red antique red tile specification. Timber roof battens are the traditional batten material and have successfully stood the test of time. The batten should be positioned so that a ridge tile will overlap the roof tile by roughly 3 inches. Tiling battens minimum length 1200mm should be fixed to the wall at maximum 114mm gauge or to counterbattens fixed at 450 to 600mm centres.

Recommended batten size see bs5534. Roof tile timber batten strip wall rafter felt linear dry verge timber batten strip roof tile fascia rafter felt. For rafter spacings up to 600mm centres the battens should be 50 x 25mm in section. Batten spacing the correct batten spacing is necessary because it corresponds to the gauge and head lap of the roof covering being installed.

For rafter centres up to 600mm centres 50mm x 25mm battens should be used for natural and fc slate and interlocking clay and concrete tiles. Rafter centres up to 600mm 50 x 25mm recommended nail size 60mm x 3 35mm. 500mm centres a length of 25mm x 38mm timber batten to the brickwork or bargeboard as shown in fig a and fig b overleaf. Battens for single lap tiles when fixed on rafters spaced at centres up to 450mm should be 38 x 25mm in section.

The choice of fixings will depend upon the type of wall construction. Seek advice from the timber supplier. Lay plain tiles in staggered bond ensuring tails of tiles align and fix each tile to timber tile batten with two clout nails. Rafter centres 600mm to 1200mm 3 5 3 acceptable batten nails acceptable batten nails table.

The double roll tile has the timeless double roman profile in a large format roof tile adding character to any building. Hold a final short strip of batten across the top of the roof just below the ridge and rest a tile on it. Timber roof battens are appropriate for all types of roofing including metal and tile but it is important to correctly assess the wind loadings in play in your specific location. The gauge margin quoted by a manufacturer will be the minimum acceptable you will need to work out the gauge you actually require for your particular roof so that a full number of gauges span from the bottom batten to the ridge this will avoid ending up with a part tile at the ridge if you use the specified spacing.

Wind classification tile fixing ancillary fixing edge of roof field of roof ridge.