Roof Flushing Detail

Stramit roof and wall flashing is generally manufactured from g300 steel with protective coatings of zincalume galvanised or colorbond.

Roof flushing detail.

Drip edge varies in dimensions but typically the flange that nails to the roof surface is about 2 5 wide and the vertical edge that directs roof runoff down and away is about 1 5 in depth. The edge of the roof has thin metal flashing that helps water drip off the roof without damaging the home or causing a leak. The detail shows the method of flashing the head of a standing seam shed roof. High wall flashing detail 10 wide sheets.

Storm proof roof 2. Wall with self terminating parapro paraflex 531. This detail is used for pipes that continue above the roof and cannot be flashed as shown in detail 9 9d. Colours stramit roof and wall flashing is available in a.

The horizontal portion is nailed to wood blocking or to a nailable deck. While some skylight manufacturers include flashing in their products sometimes roofing professionals have to create it or purchase it separately. Open valleys have metal flashing to protect this critical area of the roof. Wall base termination detail.

The cap flashing is sealed at its top edge where it meets the pipe. Other materials such as colorbond ultra colorbond stainless uncoated stainless copper and aluminium are also available. Flashing against a vertical sidewall shall be by the step flashing method. Copper locking strips of the same weight as the flashing are soldered to the pans between seams at least 6 from the wall and engage the base.

Metal roof flashing ridges are a major component in any profiled clad apex roof and are available in a range of colours and finishes to match our roofing sheets. Wall flashing with coated metal edge. This is also used in other places where the roof covering is interrupted or terminated. The cap flashing is attached to the pipe with a draw band.

Cladco galvanised steel flashing ridges are folded to a 130 degree internal angle and will flex 10 15 degrees either way dependent on the angle of your roof. The standing seams are laid flat 8 from the vertical wall folded 3 4 and secured with copper cleats spaced 12 o c. Roofs peel off from the edges so it is critical to hold them tight with the roof deck sealed on the outside we turn to flashing the edges with metal and membranes metal drip edge flashing. Roof flashing is typically used to describe the metal components that weatherproof or seal the roof system.

At the end of the vertical sidewall the step flashing shall be turned out in a manner that directs water away from the wall and onto the roof and or gutter. This takes place at all edges the perimeters penetrations walls and valleys. The copper base flashing extends a maximum of 4 onto the roof. Edge flashing and starter strip.

It extends up at least 9 and is lapped at least 4 by the counterflashing. The drip edge also gives us a nice straight edge with which to align roof shingles slates or other roofing material. Details roofing wrb flashing. Paraguard expansion joint roof to wall with parasolo flashing.